Ventrilo Normalization: Difference between revisions

From AIE Wiki
Jump to navigation Jump to search
No edit summary
 
(6 intermediate revisions by 3 users not shown)
Line 1: Line 1:
[[Category:Ventrilo]]
[[Category:Ventrilo]]


Here's how to equalize the levels of other people in Ventrilo without tweaking the volume for each person.
{| class="ambox ambox-speedy"
|-
|
| class="mbox-text" | '''Deprecated''' – '''The Alea Iacta Est Gaming Community has moved to using [[Mumble]] for VOIP communications.'''
|}
 
 
 
See the [[Ventrilo Setup]] for starting information about setting up Ventrilo.
 
 
Here's how to equalize the sound levels of other people in Ventrilo without tweaking the volume for each person.


# Go to Setup.
# Go to Setup.
Line 21: Line 32:


; Threshold = -30
; Threshold = -30
: This sets the point where we actually start changing what�s coming in. Whereas 0 is the absolute loudest you can have for an input, -60 is super quiet. Average users will probably come in somewhere around -25 to -15, with the occasional few being really quiet, which is why I have this set so low.
: This sets the point where we actually start changing what's coming in. Whereas 0 is the absolute loudest you can have for an input, -60 is super quiet. Average users will probably come in somewhere around -25 to -15, with the occasional few being really quiet, which is why I have this set so low.


; Ratio = 100
; Ratio = 100

Latest revision as of 20:22, 8 September 2014


DeprecatedThe Alea Iacta Est Gaming Community has moved to using Mumble for VOIP communications.


See the Ventrilo Setup for starting information about setting up Ventrilo.


Here's how to equalize the sound levels of other people in Ventrilo without tweaking the volume for each person.

  1. Go to Setup.
  2. Enable Direct Sound.
  3. Select the SFX Button.
  4. Select Compressor and click Add.
  5. Under Compressor Properties use the settings below.


Gain = 15
How much volume you feed into the compressor. Not really relevant unless everyone is too quiet, then you can turn this up a little; turning it up too much will sound EXTREMELY *%*%ty.
Attack = 0.01
How fast volume change will happen. example: setting this to 500 means that anything coming in will only be dropped in volume after a half a second. For vent this should be set as low as possible.
Release = 500
How fast the compressor stops changing things. not really that relevant with vent, setting it around 500 is good for voice material.
Threshold = -30
This sets the point where we actually start changing what's coming in. Whereas 0 is the absolute loudest you can have for an input, -60 is super quiet. Average users will probably come in somewhere around -25 to -15, with the occasional few being really quiet, which is why I have this set so low.
Ratio = 100
How much any sound below the set threshold gets compressed and/or modified in the volume department. If you still want to hear SOME volume variation then set this lower (2-4)... the higher you set it the closer in volume everyone will be.
Pre delay = 4.0
Mostly just deals with processing; with computer and digital processors they can look ahead a few milliseconds to see what needs to be dropped in volume or changed before it actually comes through the speakers. Highest is ideal.